General International 40-350, Manual, Page: 7 / 23

OPERATING CONTROLS FOR THE FENCE
Depending on the type of work you are shaping, either side of the fence can be moved
freely. Fence can be moved by loosening wing screws (A),(Fig.11) Proper setting can be
achieved by turning knob (B). The turning knob (B) is with scale for accurate setting.
Wing screws (A) must be then tightened to fix in position.
Each fence half should be adjusted as close to cutter head as possible.
WORK SAFETY HOLD DOWN ADJUSTMENT
Loosen knob (A), turn tension plate to desired angle. Then tighten the bolt. (Fig. 13,14).
FIG.10
B
A
B
A
FIG.11
FIG12
A
B
D
C
A
E