This machine operates on
110 V single phase power
; if you suspect any electrical problems call a qualified elec-
trician to do the verification of the electrical circuit or the machine. If you need further help with your dust collector
contact your
General® International
distributor or call our
Technical Support at (514) 326-1161
.
MAINTENANCE & SERVICING
•
All bearings are sealed and permanently lubricated. No further lubrication is needed.
•
Periodically inspect all hardware, fittings and fasteners that may have loosened due to vibration - retighten
as needed.
•
Keep the outside of the unit clean and wipe off excessive dust or dirt with a dry rag.
•
Clean the canister filter on a regular basis and replace as needed, or if damaged or perforated.
•
Periodically inspect inside all pipes, fittings, blast gates, and connectors for accumulated dust build-up
or other obstructions and clean as needed. Remove sections and vacuum or manually remove debris as
needed.
•
Check and if necessary replace all damaged parts or components.
•
Do not operate with a damaged canister filter - replace damaged filter immediately.
•
Periodically inspect the power cord and plug for damage. If necessary replace the power cord and plug
at the first signs of visible damage.
•
Use only recommended parts and accessories. The use of parts or accessories NOT recommended by
GENERAL® INTERNATIONAL may result in a risk of injury or damage to the machine.
MAKE SURE THE SWITCH IS IN THE "OFF" POSITION AND UNPLUG THE UNIT FROM THE POWER SOURCE BEFORE
PERFORMING ANY MAINTENANCE.
TURN THE SWITCH TO THE "OFF" POSITION AND
UNPLUG THE UNIT FROM THE POWER SOURCE BEFORE
CLEANING OR REPLACING FILTER CARTRIDGE OR BE-
FORE PERFORMING ANY MAINTENANCE.
CLEANING OR REPLACING THE CANISTER FILTER
After a period of time depending on the frequency of use,
the canister filter may become clogged and affect airflow
as well the overall efficiency of the unit. Should you notice
a drop in the efficiency or performance of the unit, it may
be a sign that it is time to clean the filter. If so, proceed as
follows:
1.
Turn off and unplug the machine.
2.
For basic cleaning, simply rotate the handle on the
canister several rotations. The internal flap will rub
against the corrugated inner filter and shake free any
built-up dust from inside the filter.
3.
For a more thorough cleaning, after rotating the han-
dle, detach the canister from its hangers
B
and place
it on the ground upside down.
4.
Vacuum the inside of the canister to remove any
remaining dust from inside.
5.
Re-attach the canister to the hangers.
A
B
B
19
Summary of Contents for 10-800CF M1
Page 24: ...WIRING DIAGRAM 24...
Page 25: ...25 Notes...
