General International 10-800CF M1, Setup & Operation Manual

Page: 14 / 26

14
18. Attach the canister filter to the hangers, A , using
4 x 14 mm bolts and flat washers B . Tighten the
bolts securely.
A
19. Install one end of the 6” flexible hose A on the
filter outlet and the other end on the fan housing 6”
outlet
A . Secure in place using the two 6” hose
clamps B . (If needed, refer to section in gray below.)
B
A
A
B
C
D
E
SECURING THE HOSE USING HOSE CLAMPS
20. Fit the handle on the shaft of the canister filter
and secure it in place using a 12 mm bolt and
washer
B , as shown in A . Tighten with the supplied
12 mm wrench.
21. Fit a plastic collection bag over the bottom of the
canister filter and use the belt clamp to hold the
bag securely in place, making sure the metal strap
is sitting in the groove on the lower portion of the
canister.
A
B
1. Loosen the clamp bolt as much
as possible
A to loosen the hose
clamp, then unclamp it by
pushing in opposite directions as
shown in
B .
2. Fit the opened clamp C around
the flexible hose.
3. Re-attach the clamp as shown
in
D , then tighten bolt, E , using
a Phillips head screwdriver, to
tighten the clamp around the
hose.
USE CAUTION AND WEAR GLOVES WHEN HAN-
DLING METAL PARTS SUCH AS THE BELT CLAMP,
WHICH CAN CUT IF HANDLED CARELESSLY.
B