Turn the base plate back over (right side up) and
attach the motor bracket
to the base plate. Place
the collector body with motor assembly on the brack-
et, lining up the mounting holes
. Use 4 hex head
screws.
STEP 2 - ATTACH COLLECTOR BODY W/ MOTOR ASSEMBLY
Attach the vertical support rods to the base plate as
shownm, using two 5/16” x 1/2” bolts for the front and
rear rod
and two 1/4” X 1/2” hex head screws on the
third (flat bottom) rod
.
NOTE: the front and rear support rods are identical and
have angled ends
to seat over the lip of the base. The
3rd rod
goes to the left side and has a flat bottom to sit
flush on the base plate
. It is supplied to provide addition-
al support for canister models 10-005CF & 10-005SCF only.
STEP 3 - MOUNT THE SUPPORT RODS TO THE BASE
10
With the help of an assistant line up the holes in the drum
with the holes in the support rods and secure them to the
drum using the hex head screws.
STEP 4 - ATTACH THE DRUM TO THE SUPPORT RODS
ASSEMBLY INSTRUCTIONS
• SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU
HAVE COMPLETED THE SETUP PROCESS. DO NOT HOOK-UP THE MACHINE TO A POWER SOURCE UNTIL INSTRUCTED
TO DO SO.
• BE SURE TO READ AND UNDERSTAND THIS ENTIRE MANUAL.
• USE CAUTION AND WEAR GLOVES WHEN HANDLING METAL PARTS SUCH AS THE BELT CLAMPS, WHICH CAN CUT IF
HANDLED
CARELESSLY.
• THE SOUND LEVEL OF THIS MACHINE IS RATED AT APPROXIMATELY 80-85 DB DURING OPERATION. MAKE SURE THAT
ADEQUATE HEARING PROTECTION IS USED AND THAT THE OVERALL SOUND LEVEL WITHIN THE WORKING ENVIRON-
MENT IS TAKEN INTO CONSIDERATION.
STEP 1 - INSTALL THE CASTERS
Turn the base plate upside down and using the sup-
plied wrench, attach the 4 casters with the supplied
nuts and washers.
