Using the supplied hose clamps, attach one end of the
hose to the collector body with motor assembly and
the other end to the inlet on the drum.
STEP 6 - ATTACH THE HOSE
Attach the handle to the drum using the hex head
screws to secure it in place.
STEP 5 - ATTACH THE HANDLE TO THE DRUM
If you have model 10-005CF M1 or 10-005SCF M1 (with
canister filter) skip ahead to step #9.
Fit the upper bag support into the holes on the drum
.
Slip a belt clamp through the opening in the filter bag
until it comes out through the hole at the other end
. Use the belt clamp to attach the filter bag to the
upper portion of the drum
. Before tightening the
clamp make sure the metal strap is sitting in the
groove on the upper portion of the drum to create an
airtight seal between the drum and the bag.
Install the collector bag by using the belt clamp to
attach the bag to the lower portion of the drum. Before
tightening the clamp make sure the metal strap is sit-
ting in the groove on the lower portion of the drum to
create an airtight seal between the drum and the bag.
STEP 7 - FIT THE COLLECTION BAG TO THE DRUM
USE CAUTION AND WEAR GLOVES WHEN HANDLING
METAL PARTS SUCH AS BELT CLAMPS, WHICH CAN CUT
IF HANDLED CARELESSLY.
Basic assembly is now complete and your dust col-
lector is ready to be put into service. Once the unit is
hooked up to an appropriate electrical connection,
turn on the unit and check for air leaks around the
bags
(model 10-005 M1)
or canister filter
(model 10-005CF
M1 or 10-105ASCF M1)
. If there is an air leak, peel off the
backing of the adhesive foam gasket and stick it onto
the drum, making sure the gasket is sitting in the appro-
priate groove.
If you have model 10-005 M1 with filter bag skip ahead to
step #10.
Fit the canister filter onto the drum as shown
and use
the belt clamp to hold the canister securely
onto the drum
.
Tip/Hint: To seat the canister on the rim of the drum, run a
flat piece of wood (such as a ruler) between the drum and
the black apron on the bottom of the canister
.
STEP 9 - FIT THE CANISTER FILTER ONTO THE DRUM
#10-005CF M1 or 10-005SCF M1 only
STEP 10 - INSTALL FOAM GASKET
(IF NEEDED)
11
STEP 8 - INSTALL THE FILTER BAG ON THE DRUM
– #10-005 M1 only
