General DataCommc SpectraComm ES, Installation & Operation Manuals

Page: 31 / 62

SC-ES Configuration Configuring SC-ES with Smart CLI
076R204-000 SpectraComm Ethernet Switch 3-5
Issue 2 Installation and Operation Manual
Setting up a Typical SC-ES Network
The following procedure configures the SC-ES for a typical network deployment. Before
configuring the SC-ES, ensure that the unit has already been initialized as described in the previous
section:
Initializing the SC-ES for Configuration
Note
Some ADMIN mode configuration commands (i.e., enabling the craft port or setting up user accounts)
cannot be accessed or executed via the web interface.
Note
In the configuration sample below, [brackets] indicate user-defined entries or typical entries. For the default
of any configuration setting, use the online help or refer to the listing in
Appendix A, Application Guidelines .
Management Configuration Settings
The first three steps of this procedure are required in order to configure the SC-ES for management.
You must change the SC-ES from its default settings, as shown. Throughout this procedure you can
type
?
following any command, sub-command or parameter for context-sensitive online help.
1. Configure the HTTP Service to enable access by typing:
services http enable
2. Configure the SNMP Service to enable access by typing:
services snmp enable
3. If desired, enable the Management function and enter the IP information required for Telnet,
web and snmp access by typing:
configure mgt ip-addr
[ip address] [ip mask]
configure mgt enable
Optional Configuration Settings
The remaining steps use default values pre-loaded in the SC-ES unit. If the default value applies to
your network, you do not need to re-enter it. Otherwise, enter the value that best suits your network
environment. Type
?
following any command, sub-command or parameter for context-sensitive
online help.
4. Set the system prompt by typing:
configure prompt
[es-09] or [es-18]
5. Configure the Inactivity Timer to disconnect a management session after the desired interval
(in seconds) has elapsed. Range is 0 - 10,000 sec, where 0 disables the timer.
configure inactivity
[900]
6. Configure SNMP with your site-specific information and enable SNMP for read-only (ro)
access by typing the following commands:
configure snmp community add
[community name]
ro en
configure snmp system name
[your system name]
configure snmp system contact
[your system contact]
configure snmp system location
[your system location]