General DataComm SpectraComm IP T1, Installation & Operation Manual

Page: 107 / 120

Application Guidelines SCIP Default Configurations
076R200-000 SpectraComm IP T1 Router Card A-5
Issue 13 Installation and Operation Manual
Terminal Server Configure terminal port term 1 through 8
Data rate
2400, 4800,
9600
, 19200, 38400, 57600
Parity
None , Even or Odd
Data bit:
5, 6, 7, or
8
Status
Enable or Disable
Escape sequence for connection
of the port
5 ascii characters, max,
^^^
Port description A quoted string: 72 chars max (no default)
SNMP community name Controls access to device
statistics and configuration
community name: 9 chars max,
public
access: read-only (
ro
) or read-write (rw)
status: Enable or Disable
Note: A read-only community name allows user to gather statistics from your
SCIP, but not change the configuration of the device.
A read-write community name allows user to gather statistics and remotely
configure the device. (The device supports MIB-II system group.)
SNMP traps Sends unit and port information
and alarms to a network controller Destination IP address (a.b.c.d)
Community name: 9 chars max
Status: Enable or
Disable
UDP Port (optional)
162
SNMP system name Assigns a name for the managed
node. Typically is the fully qualified
domain name of the node. A quoted string; 128 chars max
YOUR SYSTEM NAME
SNMP system contact Identifies the contact person for
the managed node adn the
method of contact. A quoted string; 128 chars max
YOUR SYSTEM CONTACT
SNMP system location Describes the physical location of
the node. A quoted string; 128 chars max
YOUR SYSTEM LOCATION
Configure Time Controls the use of Simple
Network Time Protocol (RFC2030)
and Time Protocol (RFC 868)
Enable or
Disable
Note: When configured for SNTP or TP, the device will receive and use
Greenwich Mean Time (GMT) to timestamp any generated SNMP traps, System
Messages and Alarms. When neither SNTP nor TP is configured, the device will
use a relative System Up Time for timestamping.
Time protocol Selects the time protocol
SNTP1, SNTP2,
SNTP3
, SNTP4 or TP
Time server Defines the location of the time
server Time server IP address (a.b.c.d)
Per-server NTP version 1-4 (optional)
(Default is no server specified)
User Accounts
Configuration
(For details, refer to
Chapter 3:
Configuring CLI User
Privileges
and Chapter 5:
Authentication
Protocol
Username/password for read-write
access to all SCIP functions A quoted string; 20 chars max
admin admin
Username/password for read-write
access to most SCIP functions A quoted string; 20 chars max
supervisor supervisor
Username/password for read-only
access to device A quoted string; 20 chars max
gdc gdc
Console (craft port) authentication Enable or
Disable
Table A-1 Default Configuration Profile #1 (GDC P/N 076U032-D01)
Setting Description Parameters/Default