Operator’s Manual for Power Washer
5
Figure 2-4.Insert Nozzles (number may vary)
5.
Place spray gun and nozzle extension
into spray gun holder.
6.
See Figure 2-5. Attach siphon tube.
Figure 2-5.Attach Siphon Tube
Add Engine Oil
1.
Place power washer on a level sur-
face.
2.
Verify oil fill area is clean.
3.
Remove oil fill cap and wipe dipstick
clean.
Figure 2-6. Remove Dipstick
4.
Add recommended engine oil.
NOTE
: Some units have more than one oil fill
location. It is only necessary to use one oil fill
point.
5.
Thread dipstick into oil filler neck. Oil
level is checked with dipstick fully
installed.
6.
See Figure 2-7. Remove dipstick and
verify oil level.
Figure 2-7. Dipstick Oil Level Indicator Marks
7.
Install oil fill cap/dipstick and hand-
tighten.
Fuel
Fuel requirements are as follows:
• Clean, fresh, unleaded gasoline.
• Minimum rating of 87 octane/87 AKI
(91 RON).
• Up to 10% ethanol (gasohol) is
acceptable.
• DO NOT use E85.
• DO NOT use a gas oil mix.
• DO NOT modify engine to run on
alternate fuels.Stabilize fuel prior to
storage.
1.
Verify unit is OFF and cooled for a
minimum of two minutes prior to fuel-
ing.
2.
Place unit on level ground in a well
ventilated area.
3.
Clean area around fuel cap and
remove cap slowly.
4.
Slowly add recommended fuel. Do not
overfill.
Figure 2-8. Add Recommended Fuel
5.
Install fuel cap.
NOTE: Allow spilled fuel to evaporate before
starting unit.
Water Supply
NOTE
: DO NOT run unit without sufficient
water supply. Failure to follow water supply
requirements will void unit warranty.
'$1*(5
&YQMPTJPOBOE'JSF'VFMBOEWBQPSTBSFFYUSFNFMZ
GMBNNBCMFBOEFYQMPTJWF"EEGVFMJOBXFMM
WFOUJMBUFEBSFB,FFQGJSFBOETQBSLBXBZ'BJMVSFUP
EPTPXJMMSFTVMUJOEFBUIPSTFSJPVTJOKVSZ
