Generac Power Systems G007006-0, Owners & Installation Manual

Page: 8 / 20

General Information and Setup
4 Owner’s/Installation Manual for SMM
SMM and Carton Contents
Priority Dial (A) —Sets module priority.
NOTE: PRIORITY MUST BE DIFFERENT for each
module in an installation.
Priority sets the order in
which loads recover from a load shed event. Recovery
time from a load shed event is five minutes for Priority 1.
Each priority after Priority 1 waits an additional 15 sec-
onds after the initial recovery time. See
Table 2-1 .
Lockout Switch (B) —Enables or disables lockout func-
tion. Switch positions are LOCKOUT LOAD ON GENER-
ATOR (enabled) and LOCKOUT DISABLED. See
Table 2-2 .
NOTE: Recovery time is based on priority dial settings.
See Table 2-1 .
Test Button (C) —Disables contactor output for a speci-
fied time.
LED (D) —Provides module status. See Table 2-3 .
Contactor (E)— Normally OPEN. If generator begins to
overload, the contactor opens to take load off generator
power. See
Connections .
Mounting Holes (F) —Internal enclosure mounting holes
provide clean and sturdy mounting.
Directional Arrows (G)— Provided for mounting pur-
poses.
Priority Decal (H) —Provided for recording priority of
each module in installation. Install on electrical panel.
Figure 2-1. SMM Features and Controls
A
B C D
E
F
F
H
009380
G