Operation
34
Installation Guidelines for Air-Cooled Generators
7.7 — Before Initial Start-Up
NOTE: This unit has been run and tested at the factory prior to shipment and does not require any break-in.
Operating the engine with the oil level below the ADD mark on the dipstick can cause
engine damage.
NOTE: This unit comes filled with 5W - 30 full synthetic oil from the factory. Check the oil level and add the
appropriate viscosity and amount if necessary.
7.7.1— Installation Wizard
The insulation wizard comes up the first time the generator is powered, it allows the user to input generator settings
upon power up. See Figure 7-3.
The Installation Wizard will start every time power (both AC and DC) are removed and then re-applied.
Figure 7-3. Installation Wizard Menu
*
"Generator"
"Ac
Ɵ
ve"
"Install Wizard"
"......."
"Ac
Ɵ
vate me (ENT) or"
"ESC to run in manual"
"NOT ACTIVATED !"
""
"Language"
"<- XXXXX ->"
"To ac
Ɵ
vate go to"
"www.ac
Ɵ
vategen.com"
"- English +"
"- Espanol +"
"- Francois +"
"- Por"
" Fuel Selec
Ɵ
on"
"<- XX ->"
Note: Set Fuel Type
"Serial 1234567890"
"PASSCODE xxxxx"
"Wrong Passcode"
"Try Again"
"- LP +"
"- NG +"
"Select Hour (0-23)"
"Select Minute (0-59)"
"Select Month (1-12)"
Note: Set Generator Time
"Select Date (1-31)"
"Select Year (0-99)"
"XXXXX"
"XXXXX"
Note: Finishes at status screen
ENTER
ENTER
This will only come up the
Į
rst
Ɵ
me the generator is powered. If ESC is pressed to skip the
ac
Ɵ
va
Ɵ
on process, the ba
ƩĞ
ry must be disconnected to allow ac
Ɵ
va
Ɵ
on again and this process
will reini
Ɵ
alize. If power is removed a
ŌĞ
r a successful ac
Ɵ
va
Ɵ
on, the data is remembered and the
ac
Ɵ
va
Ɵ
on steps are skipped.
ENTER
3sec delay
ESCAPE
ENTER
wrong entry
IF NOT YET ACTIVATED
ENTER
Note1: Language only shows up
Įƌ
st
Ɵ
me it is powered unless
enter is pressed to skip through
the install wizard
Note1: Can run in MANUAL only if
NOT ACTIVATED
Note2: Must disconnect ba
ƩĞ
ry to
allow ac
Ɵ
va
Ɵ
on again
