Generac Portable Products 2,400 PSI High Pressure Washer
7
7
• Run water through your garden hose for 30 seconds to
clean out any debris .
• Connect the garden hose to the water inlet. Tighten by
hand (Figure 6).
WARNING!
There MUST be at least ten feet of
unrestricted garden hose between the pressure
washer inlet and any flow shut off device, such as a
‘Y’ shut-off connector or other convenience-type
water shut-off valve. Damage to pressure washer
resulting from disregarding this warning will not be
covered by the warranty.
• Turn ON the water and squeeze the trigger on the gun
to purge the pump system of air and impurities.
CAUTION!
Before starting the pressure washer,
be sure you are wearing adequate eye protection.
• Attach the adjustable nozzle extension to the spray gun.
Tighten by hand (Figure 7).
CHECKLIST BEFORE
STARTING ENGINE
Review the assembly to ensure you have performed all of
the following.
• Make sure the handle and wireform are in place and
secure.
• Check for properly tightened hose connections (high
pressure and water supply).
• Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
• Check that oil has been added to the proper level in the
engine crankcase before trying to start the pressure
washer.
• Add the proper gasoline to fuel tank.
• Provide a proper water supply (not to exceed 140°F).
• Be sure to read the “Safety Rules” and “Operation”
sections before using the pressure washer.
HOW TO USE YOUR
PRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at
1-800-270-1408.
How to Start Your Engine
The best way to start your pressure washer for the first
time is to follow these instructions step–by–step. This
starting information also applies whenever you start the
engine after you have let the pressure washer sit idle for at
least a day.
• Place the pressure washer in an area close enough to an
outside water source that can flow at a rate of at least
2.5 gallons per minute.
• Make sure the unit is in a level position.
Figure 7 — Connect Nozzle Extension to Spray Gun
Connect
garden hose
here.
Inspect
inlet
screen.
Figure 6 — Connect Water Supply Hose to Pump
