SXBlue GPS Reference Manual
40
r
Description
0
ON
1
OFF
When the ‘,OTHER’ data field is specified (without the square brackets), this command
will enact a change in the RD1 message on the other port.
8.2.2 $JAIR
This command allows you to place the SXBlue GPS into AIR mode, where the receiver
is optimized for the high dynamic environment associated with airborne platforms.
The format of this command follows:
$JAIR,r<CR><LF>
Where feature status variable, ‘r’, may be one of the following values:
r
Description
0
ON
1
OFF
The SXBlue GPS will reply with the following response:
$>
8.2.3 $JASC,VIRTUAL
When using an external correction source, this command is used to ‘daisy chain’ RTCM
data from being input from one port and output through the other. For example, if RTCM
is input on Port B, this data will correct the SXBlue GPS position and also be output
through Port A. The SXBlue GPS acts as a pass-through for the RTCM data. Either
port may be configured to accept RTCM data input and this command then allows the
opposite port to output the RTCM data. To configure the SXBlue GPS to output RTCM
data on the current port from data input on the other port, issue the following command:
$JASC,VIRTUAL,r<CR><LF>
To configure the SXBlue GPS to output RTCM data on the other port from RTCM data
input on the current port, issue the following command:
$JASC,VIRTUAL,r,OTHER<CR><LF>
Where the message status variable, ‘r’, may be one of the following:
r
Description
0
ON
1
OFF
