then can control various projector with the visualiser.
1. Connect the visualiser to the projector with the RGB
、
VIDEO
、
S-VIDEO cables.
2. Connect the RS232 cable to the computer’s connector. The
visualiser’s RS232 port is located on its right side.
3. After completion of the connection, turn on the visualiser
，
click
[start] -> [All Programs] -> Visualiser ->
and the
following dialog box appears as below:
When the indicator of “Current RS-232 Connection Status” is green,
that means the connection between the visualiser and the
computer’s RS232 connector is good. If the indicator is red, please
check if the RS232 cable is connected correctly. When all the cables
are connected correctly, please click “Projector” to select your
projector model under the drop-down list, then click “Send”. If you
cannot find your particular projector model in the “Projector”, please
do the following:
1)
．
Select “Baud rate” and “parity” and input the projector control
code. (The baud rate, parity and control code is supplied by
21
