RemoDAQ-8017S User’s Manual
your drive of CD-ROM is F
：
then change the drive to F
：
5.
Find the setup of “RemoDAQ-8000 Utility” and run it.
6.
Please follow the steps of setup program then you can
successfully install the RemoDAQ-8000 Utility.
2.3 Basic configuration and hook-up
Before placing a module in an existing network, the
module should be configured.Though all modules are initially
configured at the factory, it is recommended to check that the
baud rate is set correctly.
Default Factory Settings
Baud rate
：
9600 Bit/sec.
Address
：
01 (hexadecimal)
Checksum
：
disable
The basic hook-up for module configuration is shown below.
Figure 2-2
Layout for Initialization the RemoDAQ module
13
