GEM
ORO ULTRATESTER 3+
20
21
loose stone’s table until the test
result it indicated
N
.
YOU MUST
FOLLOW THIS PROCEDURE
WHEN TESTING LOOSE STONES
OR THE TESTER MAY NOT TEST
CORRECTLY.
DO NOT ATTEMPT
TO TEST LOOSE STONES
WHILE HOLDING THEM IN
YOUR FINGERS OR THE TESTER
MAY NOT TEST CORRECTLY.
11. The probe tip must be cleaned
routinely to ensure proper
contact with the stone being
tested. To clean the probe tip,
take a piece of uncoated white
copy or printing paper and lay
it on a table or counter or other
flat surface. Place the tester
in a 90-degree angle to the
paper with the probe tip lightly
touching the paper. Apply enough
pressure to gently depress the
retractable probe tip slightly
inside the housing. Then carefully
rub the probe tip in one direction
on the paper to clean it.
12. Using the Optional UltraDock 3:
Place the charging station in a
convenient location near where
it will be used such as on a desk,
showcase or repair area. Take
the testers micro-USB power
cord and plug it into the rear of
the UltraDock 3, while plugging
the USB into its AC power cube
adapter. Plug the adapter into
a convenient wall outlet. You
may now simply place the
UltraTester 3+ in the charging
stations cradle with its on bottom
edge facing down, and the rear
of the UltraTester 3+ facing the
back end of the cradle. The
UltraTester 3+ will automatically
have its NiMH batteries charged
while in the UltraDock 3.
O
13. Using the Optional Test Stone
Magnifier: Insert the UltraTester
3+’s probe tip cone through the
wider opening of the magnifiers
oval shaped bracket and clip
it into place. Depending on
whether you are right or left
handed, you may conveniently
position it on either side of the
tester. Pivot the hinged magnifier
so that it is positioned in front of
the testers probe tip. You may
now view the stones you are
testing under magnification.
P
TESTING LOOSE STONES WITH
TESTING PLATE
N
TESTER IN OPTIONAL ULTRADOCK 3+
O
