GEMMA TECHNICAL HELIOS STELLAR, User Manual

Page: 14 / 76

14 | G E M M A T E C H N I C A L

Repeat the above steps for the left waist webbing but using SLOT R4 then R3 on the back plate

Insert the plastic webbing clip to the left waist webbing

Insert a webbing rubber band which will be used later to secure excess webbing
FITTING YOUR STELLAR BC

Before you install the waist buckle, adjust the lengths of the shoulder
webbings and waist webbings for a comfortable fit

A good fit is a comfortable and safe fit

First try on the A1 harness system which you have installed so far

The Quick Pull webbing buckle should be located either on the chest
or under the chest most comfortable for the individual diver. Adjust
the shoulder webbing accordingly

Pull down the integrated D-rings looped around the Quick Pull
webbing buckle. See Illustration

When fit snug the D-rings should drop approximately 10cm. If longer
or too short, loosen the tri-glides on the back of the backplate and
adjust the length.

Once the fit of the harness has been adjusted, extend your right hand
over your shoulder and try reaching the top edge of the backplate. If
your fingers touch the backplate, you have adjusted the harness
properly.