PAG.18
PAG.19
FUNCTION
ENABLING
FUNCTION
DISABLING
Push the button
N.
to enable
the function
1
Push the button
N. 2 to disable
the function
When step 4 has been done, i.e. both buttons pushed simultaneously on the
remote control, the actual programming procedure will start.
Button N.1: ENABLE
Button N.2: DISABLE
Button N.1: ENABLE
Button N.2: DISABLE
Button N.1: ENABLE
Button N.2: DISABLE
Button N.1: ENABLE
Button N.2: DISABLE
Button N.1: ENABLE
Button N.2: DISABLE
Button N.1: ENABLE
Button N.2: DISABLE
Button N.1: ENABLE
Button N.2: DISABLE
QUIT PROGRAMMING
28.0 - EXTRA FUNCTIONS PROGRAMMIG
In this section we describe the procedure to perform in case you want to
activate or deactivate one of the extra functions.
After reading point 4, follow the instructions as reported in the following page,
where the extra functions and their activation are described.
Please ALWAYS activate and deactivate the alarm system before
beginning the programming procedure.
4
2
3
With the system disabled, lift up the seat
(or open the trunk).
If the seat/top case button has
not been installed on the vehicle,
ground the GREEN/BROWN wire.
Once terminated the
programming operations,
unground this wire.
Turn the ignition key to “ON”
position.
Turning the ignition key to “ON” position, the
LED will light up for about one second.
nly during this
you can
proceed with step 4.
Warning: o
period
While the LED is “ON”, push the two buttons
simultaneously on the remote control.
The alarm system will confirm that the
programming has been enabled
and will cause the LED to light up
steadily two acoustic signals,
the first one in a low-tone beep, and second
in an high-tone bee.
ACOUSTIC SIGNALS
(enabled by Gemini)
PANIC ALARM
(enabled by Gemini)
SHOCK SENSOR
(enabled by Gemini)
SYSTEM SELF-REARMING
(disabled by Gemini)
PASSIVE ARMING
(disabled by Gemini)
ANTI-HIJACKING
(disabled by Gemini)
PRE-ALARM
(disabled by GEMINI)
1