PAG.16
PAG.17
27.0 -
(WITHOUT BROWN/GREEN WIRE GROUND CONNECTION)
The system is supplied with two remote controls and an electronic key, but
.
.
Disarm the system with a remote control or an electronic key.
t
“ON”.
P
, wait for two seconds and
p
.
T
system
.
!
!
!
!
!
LEARNING OF NEW DEVICES
saving to memory or replacement of electronic keys or radio controls could be
necessary
To perform these steps, follow the procedure below, keeping in mind that the
passive activation function MUST be disabled
With the system being disarmed, urn the ignition key to
The status LED stay on for one second; during this period, push both
buttons of the remote control or insert the electronic key into the specific
receptacle.
Two flashes of the turn signals and two acoustic signals, one loud tone and
the other acute tone, will indicate that new devices learning procedure has
been started.
ress one of the buttons on the remote control to be recognized or insert
the electronic key in the receptacle.
In case of other devices to be saved to memory
ress one of the buttons on the remote control to be recognized or insert the
electronic key in the receptacle
urn the ignition key to “OFF”, when the device saving to memory
procedure is over.
The
will notify the quitting from the program mode with a low-tone
beep and a single flash of the direction indicators
!
!
!
26.0 -
(BY BROWN/GREEN WIRE GROUND CONNECTION)
The system is supplied with two remote controls and an electronic key, but
.
.
Disarm the system with a remote control or an electronic key.
.
I
.
P
.
Turn the ignition keiy in “ON” position.
Release the provost push-button.
P
.
.
.
T
system
.
.
!
!
!
!
!
!
!
!
!
!
!
!
LEARNING OF NEW DEVICES
saving to memory or replacement of electronic keys or radio controls could be
necessary
To perform these steps, follow the procedure below, keeping in mind that the
passive arming function MUST be disabled
Lift up the seat or open a top case or, in case the perimeter protection
button is not installed, ground the BROWN-GREEN wire
nsert the saving to memory connector with button into the specific
connector; you can recognize it by the connector’s yellow colour or the
connector’s yellow sheath
ress and hold the above-mentioned button
Two flashes of the turn signals and two acoustic signals, one loud tone and
the other acute tone, will indicate that new devices learning procedure has
been started.
ress one of the buttons on the remote control to be recognized or insert
the electronic key in the receptacle
One flash of the turn signals and one acute tone acoustic signal will
indicate the new control device learning
In case of other devices to be saved to memory, press and release again
the saving to memory button, press the radio control button or put the
electronic key in its receptacle
Turn the ignition key to “OFF” when the device saving to memory
procedure is over.
he
will notify the quitting from the program
mode with a low-tone beep and a single flash of the direction indicators
Close the seat or the trunk of the vehicle or remove the BROWN/GREEN
wire from ground, if a perimeter protection button has not been mounted
CAUTION
CAUTION
Storing memory is for 8 devices.
If you store an extra device, it will automatically delete the first one
installed (position one of the alarm system memory).
They can be remote controls, electronic keys or both of them.
Storing memory is for 8 devices.
If you store an extra device, it will automatically delete the first one
installed (position one of the alarm system memory).
They can be remote controls, electronic keys or both of them.
