PAGE 12 - INSTALLER MANUAL
INSTALLER MANUAL - PAGE 13
All devices previously programmed in the system memory can be deleted.
To clear memory proceed as follows:
• With the system disarmed, open the vehicle bonnet and keep it opened or ground the GREEN
wire.
11.0 - DELETING DEVICES
To carry out the operation successfully, make sure the required electrical connections
(bonnet switch and ignition) are complete.
If there is no bonnet switch, ground the GREEN wire (20-pin connector, pos. 15).
To activate the code-learning mode proceed as follows:
• With the system disarmed, open the vehicle bonnet and keep it opened or ground the GREEN wire.
• Turn ignition key “ON-OFF”-“ON-OFF”-“ON-OFF”-“ON”.
To confirm it has entered in learn mode, the system gives 2 acoustic signals (a high and a low-
pitched sound), the turn indicators flash once and the LED turns ON.
• At the 4th rotation, leave it “ON”.
The following “ON-OFF” operations must be carried out within 4 seconds otherwise the
procedure is invalidated.
Do not close the bonnet otherwise all previously programmed devices will be erased as
described in the next paragraph.
• The system is ready to receive the device codes.
• Depending on which device is to be stored in memory, press one of the buttons on the remote
control, insert the electronic key into its receptacle, make the magnetic contact transmit (bring
contact and magnet together and then move apart), press the button on the opening detector, make
the infrared sensor transmit (see sensor instructions
.
• A short acoustic signal will confirm learning of a device.
• Repeat this same procedure to learn other devices.
• Turn ignition key “OFF”.
• Close the bonnet or remove the GREEN wire from ground (bonnet switch).
) or see
sensor
instructions
wireless hyper-frequency
• To confirm the end of the procedure, the alarm gives a low-pitched sound signal, the turn
indicators flash once and the status LED turns OFF.
10.0 - LEARNING NEW DEVICES
Storing memory is for 55 devices.
If an extra device is added, it automatically deletes the first device stored in memory.
!
!
!
!
To carry out the operation successfully, make sure the required electrical connections
(bonnet switch and ignition) are complete.
If there is no bonnet switch, ground the GREEN wire (20-pin connector, pos. 15).
!
• Turn ignition key “ON-OFF”-“ON-OFF-ON”-“OFF-ON”.
• At the 4th rotation, leave it “ON”.
• To confirm it has entered in delete mode, the system gives 2 acoustic signals (a high and a low-
pitched sound), the turn indicators flash once and the LED turns ON.
• Close the bonnet or remove the GREEN wire from ground (bonnet switch).
To clear the memory, leave the bonnet closed for at least 8 seconds.
The following “ON-OFF” operations must be carried out within 4 seconds otherwise the
procedure is invalidated.
If the bonnet is opened before 8 seconds, the devices will not be
deleted.
• The LED will switch OFF when the devices have been deleted.
• Turn ignition key “OFF”.
• A long low-pitched sound signal confirms the end of the clearing procedure.
!
!
