PAGE 14 - INSTALLER MANUAL
INSTALLER MANUAL - PAGE 15
To reset the system proceed as follows:
Disconnect the alarm power supply
hort-circuit the RED and BLACK wires of the 2-pin
connector
Power the
; 4 acoustic signals and 4 flashes of the turn indicators will confirm the operation
Remove the previously created short-circuit; the status LED will light up steady.
reset is confirmed by 1 aucoustic signal and the wailing of the siren for
approx. 3 seconds
the LED will turn OFF. There are no acoustic signals
!
!
!
!
!
!
.
S
LED
.
system
.
Turn ignition key “ON”;
.
Turn ignition key “OFF”;
.
16.0 - SYSTEM RESET
With this procedure all settings will be returned to the factory default settings.
Reset must therefore only be carried out in case of need, before programming the
system or learning the turn indicator flashes.
!
17.0 - TECHNICAL SPECIFICATIONS
Power supply 823 - 822
Current absorption @ 12Vdc with system armed and LED flashing
Working temperature range
Turn indicators relay contact capacity
Engine immobiliser relay contact capacity
Alarm cycle duration
Maximum positive current output when armed (+A)
Additional siren output current capacity
12 Vdc
15mA
From -30°C to +70°C
8 A @ 20°C
8 A @ 20°C
30 sec.
700 mA
1 A
To carry out the operation successfully, make sure the required electrical connections
(door/bonnet switches and ignition) are complete.
Any previously programmed device can be deleted as follows:
With the system disarmed, open the driver door and the bonnet and leave them open
!
.
!
!
!
!
!
Turn ignition key “ON-OFF”-“ON-OFF”-“ON-OFF”-“ON”.
At the fourth turn, leave it “ON”.
.
Close the bonnet.
.
To confirm it has entered in delete mode, the system gives 2 acoustic signals (1 Beep and1 Boop),
the turn indicators flash once and the status LED turns ON
Keep the bonnet closed (approx. 8 sec.) until the devices are completely deleted
The following operations must be carried out within 4 seconds otherwise the
procedure is invalidated.
If the bonnet is opened before 8 seconds, the devices will not be
deleted.
!
!
.
”.
The status LED turns OFF when the devices have been deleted
Turn ignition key “OFF
The end of the procedure is confirmed by a long low-pitched acoustic signal.
!
15.0 - DELETING PROGRAMMED DEVICES
!
!
!
