Designed
and
manufactured
by
GEMINI
TECHNOLOGIES
srl
‐
Via
L.
Galvani,
12
–
21020
Bodio
Lomnago
(VA)
–
Italy
Tel.
+39
0332
943211
–
Fax
+39
0332
948080
–
www.gemini
‐
alarm.com
ISO
9001
CERTIFIED
COMPANY
Rev.01
07/2018
4/9
9.1 - CONTROL UNIT AND LOUDSPEAKER (BUZZER)
1.
Find a suitable location behind the rear bumper and fit the control unit using the supplied double-sided tape and zip-ties.
2.
Use the supplied double-sided tape or screws to mount the buzzer somewhere inside the cabin where the driver will clearly hear the warning signals.
9.2 – SENSORS
The parking sensors can be fitted either from the inside of the bumper (Fig. A) or from the outside (Fig. B) with the specific snap-in adapters.
9.3 - INSTALLATION ON THE INSIDE OF THE BUMPER:
1.
Clean and degrease around the fitting holes.
2.
Choose the suitable type of adapters according to the bumper shape:
Standard (Ø 18mm hole)
Angled 10° (Ø 20mm hole) to correct the angle of the sensor heads on bumpers that curve up or down.
3.
Peel off the adhesive film on one side of the pad and apply on the front side of the adapter as shown below (Fig.1).
4.
Peel off the remaining adhesive liner and align the adapters on the 6
holes previously drilled in the bumper (Fig.1).
5.
Clip the sensors into the adapters with the arrows and the UP indication facing upwards (Fig.2).
6.
Connect the sensors to the wires coming from the control unit as indicated below, according to preference. The present instructions apply to left-hand drive vehicles,
for right-hand drive vehicles, fitting steps must be switched around.
7.
Space out the supplied adhesive cable clips along the bumper, insert the cable ties and secure the wires in place. Bundle up any excess cables.
NB: Keep all wires away from high temperature components (ex. exhaust pipe).
8.
Put the bumper back in place without bolting it up.
9.4 - INSTALLATION ON THE OUTSIDE OF THE BUMPER:
1.
Choose the suitable type of adapters according to the bumper shape and drill 6 Ø 20mm holes for both types of adapters.
2.
Press down the standard or angled adapters in place on the outer side of the bumper and proceed as indicated above for the inner installation, from step 5.
Alignment mark on top
9.0 - INSTALLATION
B
A
ECU
ECU
UP
Fig.1
Fig.2
