Contents
Chapter 1: 958A Overview ........................................................................................ 3
1.1 Dimension Drawing ............................................................................................. 4
Chapter 2: Installation ............................................................................................... 5
2.1 Installing in a Hydraulic Cylinder ...................................................................... 5
2.2 Magnet Installation ............................................................................................. 5
2.3 Mounting ............................................................................................................. 6
2.4 Set Screw Installation ........................................................................................ 6
Chapter 3: Connections & Wiring ............................................................................ 7
3.1 Wiring .................................................................................................................. 7
3.2 Pinouts and Wiring ............................................................................................. 8
3.3 Features – Automation Gain Control ................................................................ 9
3.4 Setting Zero & Span Positions .......................................................................... 9
Appendix A: Part Numbering ................................................................................. 10
Appendix B: Specifications .....................................................................................11
NOTE: Ametek has checked the accuracy of this manual at the time it was
approved for printing. This manual may not provide all possible ways of
installing and maintaining the LDT. Any errors or additional possibilities to the
installation and maintenance of the LDT will be added in subsequent editions.
Comments for the improvement of this manual are welcome.
Ametek reserves the right to revise and redistribute the entire contents or
selected pages of this manual. All rights to the contents of this manual are
reserved by Ametek.
Unpacking
Carefully remove the contents of the shipping carton and check each item
on the packing slip before destroying the packing materials. Any damage
must be reported to the shipping company. If you do not receive all of the
parts, contact Ametek at 800-635-0289 (US and Canada) or 248-435-0700
(International).
Most probes are shipped in a Tube. To remove the metal end cap, use a large,
flat blade screw driver or a metal rod and tap on the inner edge of the cap until
it pivots. Grab the cap and pull it out. Use caution as the edge of the metal
cap may be sharp.
If you have an RMA warranty claim, pack the
probe in a shipping tube or with stiff reinforcement
to prevent the probe from being bent in transit.
