Rev. 00 01/20
30
Maintenance / Repairs
OptiSelect Pro GM04-E
Gun cleaning
ATTENTION
Impermissible solvents
The following solvents may not be used to clean the gun:
► Ethylene chloride, acetone, ethyl acetate, methyl ethyl ketone,
methylene chloride, premium gasoline, turpentine,
tetrachloromethane, toluene, trichloroethylene, xylene!
Only cleaning agents with a flash point of a least 5 Kelvin above
the ambient temperature, or cleaning places with technical
ventilation are allowed!
Before cleaning the powder gun, switch off the control unit. The
compressed air used for cleaning must be free of oil and water!
Daily:
1.
Blow off the outside of the gun and wipe, clean etc.
Weekly:
2.
Remove powder hose
3.
Remove the spray nozzle from the gun and clean it with compressed
air
4.
Blow through the gun with compressed air, beginning from the
connection in flow direction
5.
Clean the integrated gun tube with the brush supplied if necessary
6.
Blow through the gun with compressed air again
7.
Clean the powder hose
8.
Reassemble the gun and connect it
Cleaning the spray nozzle
Daily or after every shift
1.
Clean the inside and outside of the spray nozzle with compressed
air.
Never immerse the parts in solvents!
2.
Check the seating of the spray nozzles.
ATTENTION
Threaded sleeve not tightened well
If the spray nozzle is just fitted loosely, there is danger of a flash-
over of the gun high voltage, which can damage the gun!
► Always tighten the threaded sleeve well!
Summary of Contents for OptiSelect Pro GM04-E
