V
03/13
34
•
Cleaning and maintenance
OptiFlex 2 B
Powder hose rinsing
If longer downtimes take place, the powder hose has to be cleaned.
Procedure:
1. Disconnect the powder hose from the hose connection on the
injector
2. Point the gun into the booth
3. Blow through the hose manually with a compressed air gun
4. Connect the powder hose again to the hose connection on the
injector
Cleaning
WARNING:
If no dust mask or one of an insufficient filter class is worn when
cleaning the manual equipment, then the dust that is stirred up from
the coating powder can cause respiratory problems.
- The ventilation system must be turned on for all cleaning work.
- A dust mask corresponding to filter class FFP2 at minimum must
be worn during any cleaning work.
Cleaning the fluidizing/suction unit
1. Remove
the
injector
2. Remove rinsing module
3. Remove the fluidizing/suction unit
4. Clean the fluidizing/suction unit with compressed air. Also blow
off the suction tube with compressed air
5. Clean the injector (see therefore the injector user manual)
6. Clean rinsing module
7. Reassemble the individual parts
Cleaning the OptiFlex 2 GM03 manual powder gun
Frequent cleaning of the gun helps to guarantee the coating quality.
Note:
Before cleaning the powder gun, switch off the control unit. The
compressed air used for cleaning must be free of oil and water!
Daily:
1. Blow off the outside of the gun and wipe, clean etc.
Weekly:
2. Remove the powder hose from the connection
3. Remove the spray nozzle from the gun and clean it
4. Blow out the gun from the connection in flow direction with
compressed air
Summary of Contents for OptiFlex 2 B
Page 12: ......
Page 32: ...V 03 13 30 Initial start up OptiFlex 2 B 24 25 26 27 28 29 30 31 32 33 34 ...
Page 34: ......
Page 38: ......
