www.gemu-group.com
31 / 45
GEMÜ 567 servoDrive
Push-fit diaphragm:
1
2
2
Item
Name
1
Recess of compressor
2
Diaphragm tab
3
Fastening spigot
1. Move the actuator to the closed position.
2. Place the diaphragm with the fastening spigot in an in-
clined position at the recess of the compressor and push
it in.
NOTICE
▶
Important:
Do not use greases or lubricants!
3. Align diaphragm tab with identifying manufacturer and
material in parallel to compressor weir.
11.1.2 Mounting the actuator
1. Move the actuator to the open position.
2. Position the actuator with the mounted diaphragm on the
valve body.
ð
Take care to align the compressor weir and valve body
weir (diaphragm size 8).
3. Tighten the fastening elements by hand.
4. Move the actuator to the closed position.
5. Fully tighten the bolts with nuts diagonally
6. Ensure that the diaphragm is compressed evenly (approx.
10-15 %, visible by an even bulge to the outside).
7. Check tightness of completely assembled valve.
NOTICE
▶
Important:
Diaphragms set in the course of time. After
valve disassembly / assembly check that the bolts and
nuts on the body are tight and retighten if necessary (at
the very latest after the first sterilisation process).
12 Electrical connection
12.1 Electrical connection - servoDrive
Establish the electrical connection as described in the control-
ler manufacturer's information.
13 Commissioning
ü
The product is installed in piping.
ü
The product is connected electrically and the control unit
configured accordingly.
1. Check the leak-tightness and the functioning of the
product (close the product and open it again).
2. Flush the piping system of new plant and following repair
work (the product must be fully open).
ð
Harmful foreign matter has been removed.
ð
The product is ready for use.
3. Commission the product.
13 Commissioning
