8
7.7 Interchanging of the relay assignments
1. Power off and on the mains voltage (overall time available as of this moment for the execution of
this procedure: 10 minutes).
2. Hold the hand-held transmitter (e.g. GF0001) close to the antenna of the GFM001.
3. Keep the key "AUF" depressed for approx. 3 sec. until an audible signal resounds (long tone).
4. After that, hold the hand-held transmitter 1 metre away from the antenna and actuate the key "AUF"
(UP) shortly. An audible signal is emitted for acknowledgement.
5. Now hold the hand-held transmitter close to the antenna again and actuate the key. The assignment
of the sense of rotation of the motor to the control commands "RETRACTING“ and "EXTENDING“ is
changed and an audible signal resounds for acknowledgement. The changes are stored and the
control returns to normal operating mode again.
7.8 Cancelling of all learned settings and codes
1. Power off and on the mains voltage (overall time available as of this moment for the execution of
this procedure: 10 minutes).
2. Hold the hand-held transmitter (e.g. GF0001) close to the antenna of the GFM001.
3. Keep the key "EIN" (ON) depressed for >10 seconds until, after 3 seconds, an audible signal
resounds (short tone) and until, after the expiry of another 5 seconds, another audible signal
resounds (long tone).
4. Immediately let the key "EIN" (ON) go again when hearing the long tone.
5. All values stored beforehand have been cancelled and the control operates in normal operating
mode again.
Note: The relay assignments will all be reset to the condition as delivered (see sub-chapter 4.2)
when doing so.
8 Audible signals emitted by the control for fault diagnosis
Sequence of tones
Cause
1 tone
"Power on" signalling message after mains power on.
1 tone
The learning mode operation was activated.
1 tone
A radio code for the execution of an UP and of a DOWN
travel was stored.
Many short tones emitted shortly
Fault message: The radio code to be learned has already
one after the other
been assigned otherwise.
6 tones
Fault message: The learning procedure was aborted
by reason f a timeout.
1 very long tone
The radio codes and all learned settings were deleted.
1 tone
The system has switched over to the next memory area.
1 tone
The assignment of the relays to the travel directions
RETRACTING and EXTENDING has been interchanged.
Control signals: S-O-S
Fault message: no storing possible, memory module defective.
The control needs to be mended.
Short tones emitted in
Fault message: data stored in the memory module got lost.
intervals of approx. 500 ms
Submit the control to a new learning procedure. In the event
this fault reoccurs, the control needs to be mended.
6 tones
Fault message: sensors not supported.