7
7.4 Learning of a sensor
1. Power off and on the power supply of the awning control system shortly (overall time available for
the execution of the learning procedure as of this moment: 10 minutes).
2. Hold the hand-held transmitter close to the antenna of the GFM… awning control and keep the key
"AUF" (UP) depressed for approx. 3 sec.
¨
An audible signal resounds.
3. After that, hold the sensor or special transmitter to be learned at least 1 metre away from the antenna
and actuate it shortly.
¨
The control acknowledges by emitting an audible signal and changes all
automatically over to normal operating mode. The sensor learning procedure is now completed.
4. A second sensor coding can be learned now.
7.5 Learning of intermediate positions
The following should be noted with regard to this learning procedure:
Regarding the awning extension procedure, intermediate stop positions can be learned on a timeline
from 5 to 140 second. The restriction of the timeline ensures that no other than intermediate stops can
be learned that the operator can actually perceive as such.
The learning of intermediate conditions is enabled only subject to the condition that
the awning must have been retracted completely and that the motor run time has
expired (155 sec.).
The learning procedure can be performed in a convenient manner while operating in normal operating
mode. All actually learned hand-held transmitters can be used for this purpose. Learned intermediate
positions can, for extending purposes, be displaced at any time on the aforementioned timeline.
To learn an intermediate position, proceed as follows:
1. Use the related transmit key in order to trigger and "EXTENDING" motion travel and keep the key
depressed for approx. 5 seconds while doing so.
2. The drive motor stops after 4 seconds, shortly moves in "EXTRACTING" travel direction, stops
again and continues moving in "EXTENDING" direction.
The "learning" of an intermediate position has thus been initiated and the transmit key can be left off.
3. Stop, upon the attaining of the desired intermediate position, the moving sun shade by actuating the
related counter-key and hold this key depressed for approx. 5 seconds.
4. After the expiry of 4 seconds, the learned intermediate stop position is stored in a power failure safe
manner.
5. The awning performs, in order to confirm that the learning procedure has been successful, a short
movement in both travel directions. The counter-key can now be let off again.
7.6 Cancelling of intermediate stop positions
1. Use the related transmit key in order to trigger and "EXTENDING" motion travel and keep the key
depressed for approx. 5 seconds while doing so.
2. The drive motor stops after 4 seconds, shortly moves in "EXTRACTING" travel direction, stops
again and continues moving in "EXTENDING" direction.
3. Wait for another 5 seconds after the attaining of the end Position, then actuate the counter-key
(RECTRACTING) for 5 seconds until the control systems triggers a short travel motion of the
awning. The cancellation of the intermediate position is now completed.