Note: The rotor must be installed with the “rotation” arrows pointing in the same direction as the forward rotation of the
wheel.
3.3.2Mounting the adapter and caliper
1. Mount the relevant adapter to the caliper body. Insert 5mm bolts through the two adapter slots on the body and screw
into the holes on the adapter. Do not tighten yet.
2.Mount the caliper body and adapter to the frame/fork by placing the slot in the caliper body over the rotor. The
mounting holes on the adapter should be behind the frame/fork mounting holes (the hub side). Screw and tighten two 5mm
Allen bolts into the upper and lower holes in the frame/fork mount. Final tightening torque 6-8N.m.
3.Check that eh rotor is centered between the disc brake pads, and tighten the two bolts holding the caliper to the
adapter. To re-adjust the caliper positioning, loosen these two bolts and slide the caliper over until it is centered on the rotor,
then re-tighten the bolts. Final tightening torque 6-8N.m.
3.3.3 Installation of brake cable
1.
Insert the cable through the cable adapter barrel on the caliper.
2.
Making sure that the cable housing is firmly sealed within the cable adjuster barrel, insert the end of the cable
through the anchor bolt on the caliper. Take up slack in the cable, then tighten the cable anchor bolt. Final
tightening torque 6-8N.m.
3.
Adjust the screw of the brake lever to fasten or loosen the brake cable.
Note: Be sure no more 20mm excess cable beyond anchor bolt.
3.4Installation of folding bike handle
1.Take out the handle , and remove the protective paper cover of the stem.
2.Insert the stem inside the Front fork stand pipe, and adjust the direction and depth,
3.Tighten the bolt inside the stem with 18N.m torque.
4.Lock the stem and folding parts.