3.2Installation of front wheel
3.2.1Installation of common front wheel
1.
Take out the front wheel, and loose the nut on the front hub;
2.
Remove the black plastic rack below the front fork, and place the front wheel hub into the front fork contact pin;
3.
Turn the nut to the front wheel hub, and tighten the nut with 15mm open-end wrench by 25-30N.m torque and put
the cover on the nut.
When fastening the nut for front wheel hub, press down the front fork appropriately so that the front wheel hub can
work closely with the front fork.
3.2.2
Installation of V brake
1.Take off the protect cover of V brake, and put V brake in the cage.
2.Squeeze V brake, and make the V brake cable in the V braket, then use M5 hexagonal wrench to fasten the bolt.
3.Hold the V brake repeatedly and see whether the brake shoes are symmetrically
Positioned on both sides of the rim. If not, please readjust
3.3Installation of front brake
3.3.1Mounting the rotor to the hub
1.Remove the wheel from the bike. Attach the rotor to the hub with the supplied Torx bolts and tighten with a T25 Torx
wrench. Final tightening torque:6.2 N.m.
2.Make the side with Tektro logo out (rotor must rotate same direction as wheel set) Tight rotor screw then install the
wheel on the front fork or frame.