![background image](http://html1.mh-extra.com/html/gehl/dyna-handler-562/dyna-handler-562_operators-manual_2205884052.webp)
CHANGE HYDRAULIC RETURN
FILTER ELEMENT
This element is a cartridge type accessible from a hous-
ing on top of the hydraulic reservoir. Initial replace-
ment is after the first 100 hours. See illustration.
Remove the top cover of the housing. Remove the ele-
ment and discard. Insert the new element onto the
housing and Replace the cover.
CHANGE AXLE DIFFERENTIAL
& PLANETARY OIL
Differential
1. Remove the three drain plugs and drain out the old
oil. Replace the drain plugs (see illustration).
IMPORTANT:
DO NOT discharge oil onto
ground. Catch and dispose of per local waste dis-
posal regulations.
2. Remove the check and fill plugs. The larger hex
head fill plug is located on the same side as the drain
plug. The small allen wrench check plug is located on
the opposite side of the fill plug.Fill the differential
with oil as specified in the LUBRICATION chapter.
When the oil overflows the check hole, replace the
plug. Wait 10 to 15 minutes and repeat this process
3. Refill the transmission with new oil as shown in
the Lubrication chapter of this manual.
IMPORTANT:
DO NOT OVERFILL! lf the oil
level is too high, oil foaming, excessively high oil
temperature and oil leakage at the seal could
result.
4. Start and run the machine long enough for the oil
to circulate and warm slightly. Recheck the level with
the dipstick.
CHANGE RADIATOR COOLANT
Drain, flush and refill the cooling system as follows:
IMPORTANT:
Do NOT discharge coolant onto
ground. Catch and dispose of per local waste dis-
posal regulations.
1. Loosen the radiator cap to it’s stop. This will
release any system pressure. Remove the cap when all
pressure is bled off.
2. Open the radiator drain cock. Remove the water
jacket drain plug from the engine block. When all
coolant is drained, flush the system with clean fresh
water. Allow the flush to drain completely.
3. Replace all drain plugs and tighten the radiator
drain cock. Clean out the cooling fins in the radiator
with water pressure or steam.
NOTE:
When cold weather is expected, fill the
cooling system with a 50-50% mixture of water
and ethylene glycol anti-freeze.
4. Inspect the radiator cap seal before installing it.
Replace it if it appears defective. The 10 PSI (69 kPa)
pressure cap and engine thermostat work in conjunc-
tion with each other to maintain proper engine cooling.
NOTE:
Check the engine temperature lamp,
every minute or two, after coolant has been
changed. Air pockets can form. It may be neces-
sary to refill the cooling system after a short peri-
od of use, as the air will naturally bleed out of the
system.
WARNING
Remove the radiator cap only when the engine
is cool, or painful burns could result.
Reservoir Filter Removal
Housing Top
Filter Element
Filter Housing
TOP OF
RESERVOIR
WARNING
When servicing the hydraulic system, lower
the boom to the ground.
907880/AP1298
50
PRINTED IN U.S.A.
Summary of Contents for Dyna-Handler 562
Page 8: ...INTENTIONALLY BLANK PAGE 907880 AP1298 6 PRINTED IN U S A Courtesy of CraneMarket com...
Page 20: ...907880 AP1298 18 PRINTED IN U S A THIS PAGE INTENTIONALLY BLANK Courtesy of CraneMarket com...
Page 38: ...THIS PAGE INTENTIONALLY BLANK 907880 AP1298 36 PRINTED IN U S A Courtesy of CraneMarket com...
Page 70: ...Courtesy of CraneMarket com...