918215/CP0407
58
Printed in U.S.A
SERVICE AND STORAGE
1448 PLUS
NOTE:
Twist the jumper cable clamps on the
battery terminals to ensure a good electrical
connection.
6. Start the paver. If it does not start immediately,
start the jumper vehicle to avoid excessive
drain on the booster battery.
7. After the paver is started and running
smoothly, the second person should remove the
jumper cables, negative (-) jumper cable first,
from the jumper vehicle battery.
8. Remove the jumper cables from the paver. Do
not short the cables by allowing them to come
together.
Allow time for the paver alternator to build up a
charge in the battery before operating the paver or
shutting off the engine.
NOTE:
If the battery frequently becomes
discharged, check the battery for dead cells
and troubleshoot the electrical system for
possible short circuits or damaged wire
insulation.
Air Cleaner Element Maintenance
IMPORTANT:
NEVER use an air cleaner
element that is damaged. Engine wear and
failure can result if dirt enters the engine
through a hole in the element.
1. Open the latches (1, Fig. 37) securing the air
cleaner cover (2).
2. Remove the cover and the air cleaner element
(3).
3. Refer to the engine manual for air cleaner
element servicing information, or replace the
element with a new one.
4. Clean the inside of the air cleaner cover (2).
5. Re-install the air cleaner element (3) into the
air cleaner housing.
6. Re-install the air cleaner cover (2) on the
housing and secure with latches (1).
Fig. 37 - Air Cleaner
Lubricate Grease Points
See “Grease Fitting Locations” on page 48 for
fitting locations and details.
SERVICE AT 50 HOURS
(New Paver Only)
The following oil and filter changes should be
performed after 50 hours on a new paver: After
performing these changes for the first time,
thereafter, perform them according to the regular
maintenance schedule. Refer to “Service Every
250 Hours” on page 58.
•
Engine oil and filter
•
Hydraulic filter elements
•
After performing these changes, perform them
according to the regular maintenance schedule.
Refer to “Service Every 250 Hours” on
page 58.
SERVICE EVERY 250 HOURS
Also complete the service checks in: “Service
Every 10 Hours or Daily” on page 54; and “Service
Every 50 Hours or Weekly” on page 56.
Check Screed Bottom Plate
Inspect the bottom plate of the screed for wear.
1
2
3
Summary of Contents for 1448 Plus
