gefran GFW adv Series, Instruction Manual For Configuration And Installation

Page: 26 / 32

26
80427A_MSW_GFW-ETHERCAT_07-2018_ENG
E2 E7
Mono Two Three Mono Two Three
GFW 40-250 A
Single
  
✗ ✗

Bridge 2 ✗ ✗ ✗ ✗ ✗

Bridge 3 ✗ ✗ ✗ ✗ ✗

Bridge 4 ✗ ✗ ✗ ✗ ✗

GFW 400-600 A
Singolo
✗ ✗ ✗ ✗ ✗

Bridge 2
✗ ✗ ✗ ✗ ✗

Bridge 3
✗ ✗ ✗ ✗ ✗

Bridge 4 ✗ ✗ ✗ ✗ ✗

The difference between the two-phase and monophase is that the two-phase contains the map of 2 zones instead of
just zone 1.
The difference between the three-phase and the two or monophase is that the three-phase contains the map of 3
zones instead of zone 1 or 2.
To use the devices, you must “install” them in the engineering software catalogue.
In our case, it is Twincat.
Copy the files (using TwinCAT 3.1) to the following path:
C;\TwinCAT\3.1\Config\IO\EtherCAT\
In the environment, it is necessary to make them read the new files, by refreshing the library using the
Reload Device Descriptions control
Found in the menu
TWINCAT/EtherCAT Devices
Insert the Device through
PROJECT\AddNew Item