GEFRAN-SIEI ARTDrive Vector V2 400Vac Series, Instruction Manual

Page: 129 / 387

Index
MENU MENU
MENU MENU
MENU
[Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
ARTDrive V2 series - Instruction Manual Chapter 6 Parameter • 129
The status of the digital selector is read by the drive only when the output of the inverter
bridge is disabled. As a result, it is not possible to switch between local and remote
source for main commands while the motor is running.
N
OTE
!
Normally the Stop key acts as Emergency stop, when the source of main
commands is not the keypad.
For more details, see
C00-24
parameter description below.
C00.04 Dig Enable src N/A RWS Ipa4000 PList 17 PIN V-F-S-B Full 156
Ipa 4000 - NULL = Default
It allows to select the signal to generate a digital Enable command.
ª ª ª ª ª
Pick List 17
C00.05 Dig StrStp src N/A RWS Ipa4000 PList 17 PIN V-F-S-B Full 157
Ipa 4000 - NULL = Default
It allows to select the signal to generate the a digital Start (1) command and a digital Stop
(0) command.
ª ª
ª ª ª
Pick List 17
C00.06 FastStop src N/A RWS Ipa4000 PList 18 PIN V-F-S-B Easy 154
Ipa 4000 - NULL = Default
It allows to select the signal to generate the FastStop command.
ª ª
ª ª
ª
Pick List 18
C00.07 ForwardStart src N/A RWS (*) Plist 03 PIN V-F-S-B Easy 8083
(*) Ipa 4001 - [1] ONE = Default (Europe)
Ipa 4021 - [2] DI 1 mon = Default (American)
It allows to select the signal of Forward command of 2-wires and FRC or Start command
of 3-wires; see
C00.25 - FRC cmd mode
description below.
ª ª
ª ª ª
Pick List 3
C00.08 Reverse src N/A RWS (*) Plist 03 PIN V-F-S-B Easy 8084
(*) Ipa 4001 - ONE = Default (Europe)
Ipa 4022 - DI 2 = Default (American)
It allows to select the signal of Reverse command; see “ C00.25 - FRC cmd mode”
description below.