6.
Remove the 5V DC power supply from the
HDMI Detective Plus
.
7.
Set the write-protect switch to the “D” position (enable) in order to prevent an
accidental erasure of the stored EDID.
8. Use the included HDMI cable to connect the source to the
HDMI Detective
Plus
.
9. Apply power to the source.
If a computer is being used as the source, restart the computer only after all
connections have been made.
Wiring Diagram for the HDMI Detective Plus
7
CONNECTING THE HDMI DETECTIVE PLUS
IMPORTANT:
If the source uses HDCP, then DIP switch 4 must be
enabled in order to enable HDCP pass-through. In this case, the
display must also be HDCP-compliant. Refer to your source and
display manuals for HDCP compatibility.
NOTE:
If the
HDMI Detective Plus
does not initiate the recording
sequence, indicated by a flashing green LED, unplug the display
and 5V DC power supply from the unit and repeat steps 2 and 3.
If a solid red LED is indicated after several unsuccessful recording
attempts, it is possible that the EDID from the display is bad. In this
case, see page 8 for instructions on using a built-in EDID.
EXT-HDMI-EDIDP
Hi-Def Source
Monitor
HDMI Detective Plus
HDMI CABLE
