page | 35
Active on link mode
Under
Active on link
mode, a maximum of four USB devices can be used within a system.
In the diagram, on the previous page, the system is already using the maximum number of
USB devices (2 USB devices per Receiver). If we had two more Receiver units (making
a total of four Receiver units), we could have connected a single USB device to each
Receiver unit. To switch to
Active on link
mode, follow the instruction below.
1.
Access the Web interface for the Sender unit.
2. Click the
Functions
tab.
3. Locate the
USB over IP
group and make sure the
Enable USB over IP
box is
checked. This is the default setting.
4. Click the
Active on link
radio button within the
USB over IP
group.
5. Click the
Save
button within the
USB over IP
group.
6. The following message will be displayed, at the top of the page, indicating that the
new Serial over IP options have been applied.
7. Click the
Reboot
button at the bottom of the page.
8. Repeat steps 2 - 6 for the Receiver unit.
Operating the DVI KVM over IP with Local DVI Output
USB Control
