Geemarc LoopHEAR 102, User Manual

Page: 16 / 56

15
The RED LED is flashing
•
Charge the battery
The LoopHEAR
TM
keeps on switching off
•
Make sure that the batteries are fully charged
You cannot hear clearly due to interference or you cannot
hear at all
•
Make sure the LoopHEAR
TM
is switched on and facing you
•
Move the LoopHEAR
TM
closer to you
•
LH102 produces minimum 400mA per meter at a distance of
80cm in compliance with specification EN60118-4. This
produces an effective magnetic field of 2.5M or more
depending on the sensitivity of the hearing aid or listening
device. For example, when used with the Geemarc products
LH10 or LH20 a distance of 3M can be achieved. The
magnetic field strength can be adjusted with the Loop current
potentiometer on LH102 rear panel (see page 12 item 5 in
your user guide) which can in such case also adjust the
distance of detection.
BATTERY USAGE:
To ensure that your LoopHEAR
TM
is always ready for use please
follow the recommendations below:
•
Always switch off when not in use
•
Always recharge the batteries after continuous use for more
than 6 hours or when the red LED is ON
•
Recharge the batteries every four months if the unit has been
switched OFF for long periods of time
As a rough guide the battery will allow the following usage
depending on the volume levels and ambient noise:
•
Standby when turned Off 4 MONTHS
•
Standby when turned On but not in use 1.5 to 2 DAYS
•
In continuous use from fully charged battery 5 to 8 HOURS
TROUBLESHOOTING