Geemarc CC10, User Manual, Page: 6 / 16

3
SETTING UP SETTING UP
SETTING UP SETTING UP
SETTING UP
To set up follow steps 1-3
Don't use the phone until after you've charged the handset for 24 hours.
You do this in step 2.
STEP 1: Connect to the mains Connect to the mains Connect to the mains Connect to the mains Connect to the mains
Plug the adaptor lead into the adaptor socket at the back of the telephone
base unit. Then plug the adaptor into the mains and switch on. Don’t plug
into the telephone socket yet. The Power light will come on. Keep the
telephone base unit plugged in - the telephone won't work without
power.
STEP 2 STEP 2
STEP 2 STEP 2 STEP 2 : Charge the handset
Charge the handset
Charge the handset Charge the handset Charge the handset
Don't use or attempt to set up the phone till after you've charged
the handset for 24 hours and fitted the handset aerial.
1. Insert aerial into the hole at the top of the handset and Tighten the base
ring finger tight.
2. Set the handset On/Off switch to On.
3. Leave the handset on the main base unit for 24 hours.
Note: The Charge light will stay on even after the handset is fully charged.
4. Pick up the handset, push the On/Off switch to Off for a few seconds then
back to On.
5. Place the handset on the main base unit charge recess.
The Charge light will come on and you'll hear a beep*.
If you do not hear a beep:
¨
Leave the handset on the main base unit for 20 minutes.
¨
Pick up the handset, push the On/Off switch to Off for a few seconds
then back to On. Replace the handset back on the base and you'll hear
a beep.
Repeat Step 2 item 4 and 5, for each additional handset you may
have - after charging for 24 hours in a pod charger or the main base
unit charging recess.
Note: The beep is to confirm that the handset is permanently linked,
for communication, to the main base unit. Please also note that the
linking for communication can only be made by placing the handset
on the main base unit and not one of the remote pod chargers.