Geekpure RO-TW, Installation And Maintenance Manual

Page: 14 / 23

Step 1
Step 2
Step 3
Installing Tubing Into Fittings
Insert the clip
Pull out the water pipe
Pull out the water clip
Press the inner claw
Pull out the water pipe
①
②
③
④
①
②
③
push the tube into the
fitting and up to the
tube stop
Pull on the tube to check that it is secure. Test the system
before use.
Cut the tube square and remove burrs
and sharp edges. Ensure that the outside
diameter is free from score marks. For
soft or thin walled plastic tubing we
recommend the use of a tube insert.
Push the tube into the fitting and up to
the tube stop
Install the water tube
1. Locate the unit in the desired position. Make sure it is at least 3"
off the floor. Level it and mark the location of mounting screws.
2. Install the screws. Leave 1/4" of the screw head out from the
wall.
3. Install the mounting bracket slots over the screws and hang the
unit.
NOTE: THE UNIT MUST BE INSTALLED BY HANGING THE
BRACKET ON THE WALL SO THAT THERE IS NO WEIGHT
ON THE FILTERS. THE SYSTEM IS NOT DESIGNED OR
INTENDED TO SIT ON THE FLOOR WITH THE WEIGHT
SUPPORTED BY THE REPLACEABLE FILTER CARTRIDGES.
12