1. Feed the threaded nipple through
sink or counter mounting hole and
orient the faucet as shown. From
below sink or counter, assemble
the flat washer and hex nut on
threaded nipple and tighten by
h a n d . A f t e r c h e c k i n g f a u c e t
orientation, tighten with a wrench
until secure.
2. Install the faucet adaptor fitting
(shown below) and tighten until the
fitting bottoms out on the o-ring
inside to create the seal. Tighten
with wrench until secure.
3. Insert the 3/8" white tube into
the quick connect fitting.
To make the faucet mounting hole (if sprayer or second hole is not
used), check below to make sure the drill does not interfere with
anything below the sink. Center punch a small indent at the
desired faucet location. (2” flat surface is required, not exceeding
1-1/4” in thickness). Drill the 1/8” pilot hole. Drill the ½” hole for
the faucet shank to fit through. Clean up sharp edges.
Mounting the Faucet
9
Porcelain, Enamel, Ceramic on Metal or Cast Iron Sinks
For porcelain/enamel sinks marble or granite counter tops refer to
Manufacturer/Supplier for proper drilling instructions.
Installation procedures for stainless steel sinks
Recommended tools:
·
Center punch
·
Variable speed drill
·
High speed drill bits
·
Protective gloves & eye protectors
Summary of Contents for RO-TW
Page 23: ...www geekpure cc ...
