Page 17 (Revision 2.0) Copyright © 2018 GeeTramp® All Rights Reserved.
Step 4.2.1
Thread the bungee up through the mat,
pad’s attac
hment loop and down through
the mat (on the other side of the spring).
Note: Ensure the bungee is routed in
between the mat loops like shown in the
picture.
Step 4.2.2
Thread the other end of the Long Bungee
through the top of the wriggle bar and join it
by looping it over the plastic ball.
Repeat this method for all inner pad
attachments.
Step 4.3.0
Starting with any of the Short or Long Pads
(Ref #13,14): lift the pad up to access the
underside and locate the brass eyelets. Pinch
the eyelet area so the eyelet holes line up.
The Bungee can then be threaded through.
Step 4.3.1
Once the Bungee is through the brass
eyelets, loop the Bungee around the main
frame as shown. Rotate it around, so it
’s
repositioned so the head is on the inside of
the frame.
Repeat this step until all Bungees are
installed.
Note: The safety integrity for the user is dependent on the safety pads remaining correctly
positioned over the frame. It is strongly advised to check the position of the safety pads before
using the trampoline each time.
Congratulations, you’ve now fully assembled your GeeTramp® StringPro trampoline.
