Page 12 (Revision 2.0) Copyright © 2018 GeeTramp® All Rights Reserved.
Step 2 - Mat
How to Use the Spring Tool
1.
If your Springs (Ref #11) have the same
hook end style at each end then go to Step
3. If your springs have a
“short hook” and
“long hook” end of the spring
like the image
then take note for the next step.
2.
Position the S
pring “short hook” into the
corresponding Spring Attachment Wire (Ref
#10), then use the Spring Tool (Ref #12) and
hook the “long hook”
.
3.
Pull the Spring Tool until the spring is
attached to the frame edge wriggle bar, then
disengage the Spring Tool leaving the
Spring in the assembled position.
Warning: Please take care where your hands and other parts of the body are placed when pulling
springs. Be aware that you are placing stored energy into the spring and if the spring is not
restrained correctly it can cause injury to you or anyone else in the vicinity.
Step 2.0
Install a Spring (ref #11) onto the corner
ring of the Mat (ref #9) and frame. Repeat
for all 4 corners.
Note:
Take care that the mat doesn’t get
dirty by contacting the ground or using
soiled hands as this can affect the painting
process.
Step 2.1
Install further corner springs onto the mat
corner steel round ring, increase so there
are evenly spaced springs at each corner.
Note:
If Gold finished springs are provided install
3 springs per corner. If Galvanised springs
are provided install 4 springs per corner
Short Hook
Long Hook