26
CODE
MESSAgE
hl
high limit circuit has tripped!
FlO
No Flow condition for more than 2 hours
FlO
No Flow condition
hR
A hardware error was detected (Relay stuck)
Oh
Spa temperature is too high
Pr
temp probes or detection circuit are defective
AOh
Elevated internal temperature
FlC
the pressure switch is closed
SP in
Input voltage issue
Rh NC
Comm error between inxm2 - intherm
Rh ID
inxm2 and intherm incompatible
SC ER
Error detected during the learning mode
F1
inxm2 Fuse # 1 is blown
F2
inxm2 Fuse # 2 is blown
F3
inxm2 Fuse # 3 is blown
ER1
SwimSpa config : slave unit is missing
hr
hardware error was detected (thermal fuse)
uPl
the spa pack does not have valid software
Please insert valid instick to reprogram spa pack
CFlO
No Flow condition
hIBr
Add fresh water to the spa
hiBr
Add fresh water to the spa
loBr
Add BromiCharge to spa water
NoBr
Add BromiCharge to spa water
Comm
verify cable connections
Supp
Connect power cord to 240 v source
the list below shows the different error messages that can appear on the home screen
Refer to the troubleshooting and error codes section of the techBook for your spa pack system
Please note that if you are in swim spa configuration, the message may be followed by a Master or Slave
to designate from which pack the error is coming
Error messages
