Printed in USA © 0504
T-310
8
Geberit In-Wall Pressure Assist Toilet System
Installation & Maintenance Instructions
WALL HUNG BOWL INSTALLATION
45
S
S/2
4
Bevel the rough and sharp edges as shown to ensure a smooth insertion into the pipe spigots on the wall.
Spigot
Side
Spigot
Side
B
A
(A + B - 1/8")
C
Gasket Side
1/8"
3
1. Add dimensions A and B, then subtract 1/8" to get
dimension C.
2. Using this dimension, mark a line on each pipe,
measuring from the gasket side.
3. Cut off the excess on the spigot side of each pipe.
Fill
Discharge
A
1
1. Remove the plugs from the fill and discharge open-
ings of tank & carrier assembly.
2. Install the bowl inlet adapter and discharge adapter
fully into their respective holes.
3. Assemble the gaskets onto the inlet adapter and
discharge adapter.
3. Place a straightedge flush against the wall and
across the fill pipe and mark dimension A. Repeat for
discharge adapter.
4. Remove inlet and discharge adapters from
tank & carrier assembly
B
Measure from edge of bowl
2
1. Install the inlet and discharge adapters, with gaskets,
fully into the bowl.
2. Measure and mark dimension B on both pipes.
3. Remove pipes from bowl.
ww
w.TheA
nwserLine.com
