Keypad
Factory setting = 1-8
Please read first - then do the programming!!!
Program 1
Input of a new mastercode
Before programming your Cody Universal 2 with your personal codes, please check the faultless
function of the appliance with the help of the factory‘s pass code 1234 and the button.
Usually, any programming is made via your personal mastercode. In order to get familiar with that kind
of programming, you start with the input of a new pass code, which replaces the one preset by the
factory (1234). The procedure is explained under item “Program 2“.
After that please change the factory set mastercode to your personal code of choice.
Enter 8 digit
mastercode
The new mastercode is now saved!
Program 6
Entering a pass code
Keypad
Enter 4 or 5 digit
pass code
button
push
button
push
push
button
A correct code is detected, the corresponding relay is switched!
Programming
instructions
Attention / Note
In case you made a mistake on programming, you can start over again by pushing the
button
Sound signal
2x long
push
button
push
button
Sound signal
1x long
Enter 8 digit
NEW
mastercode
button
push
sound signal
1x long
Before the actual pass code, you can press any other keys to prevent fraud.
If an incorrect pass code is entered, you will hear a sound signal (3 beeps).
Entering a new pass code is only possible after the lock-out period (factory: 20 sec.) which end is
signalled by a long sound signal.
