Gearmore T230, Operation, Service And Parts Manual, Page: 18 / 47

15
MAINTENANCE
EVERY 8 WORKING HOURS
• Grease the PTO shaft crosses.
EVERY 20 WORKING HOURS
•
Grease the PTO shaft inner drive tube.
EVERY 50 WORKING HOURS
•
Check the oil level in the external rotor bearing through the inspection plug B. If
needed remove the plug A and add SAE EP 80W90 oil (
picture 11
).
•
Check the oil level in the case/bevel gear pair by removing gearbox's upper oil plug
(A -
picture 12
); oil level should be contained between the 2 nicks of MIN & MAX
of the dip stick oil plug (B -
picture 11
). If needed add SAE EP 80W90 oil.
•
Check the oil level in the side transmission (A -
picture 13
). If needed add SAE EP
80W90 oil.
•
Make sure that all the screws and bolts, especially on the blades, are tightened.
• Check slip-clutch spring tension (1500 Nm).
EVERY 500 WORKING HOURS
• Change the oil of the case/bevel gear pair, side transmission and rotor support; use
SAE EP 80W90 oil. Contact the closest dealer for this maintenance activity.
The old oil must be disposed of in compliance with
the local laws where these activities are carried out;
do not spill or dispose of waste oil on the ground.
Picture 11
Picture 12 Picture 13