WARNING
:
To avoid eye injury, do not stare directly into the light beam or shine the
beam directly into anyone’s eyes. This product is not designed, intended, or
recommended for children or hazardous environments.
CAUTION:
The flashlight may become warm or hot after extended periods of use.
This is typical for high-powered flashlights and does not cause damage to the
flashlight.
WARNING:
Lithium-ion batteries can present a fire, explosion, and burn hazard. Use
only 18650 battery cells with a protection circuit produced by Panasonic, Sanyo, Sony,
Samsung, or LG. Remove the battery when the flashlight is not in use. The use of other
cell manufacturers or the failure to follow the battery manufacturer's safety instructions
may result in fire, explosion, personal injury, and damage to property.
WARNING:
Always follow the battery manufacturer’s instructions as to the proper
usage, handling, storage, and disposal of batteries. Use only batteries from a reputable
manufacturer. Do not mix different brands or types of batteries in the same flashlight.
Replace all batteries at the same time. Failure to follow safety instructions may result in
personal injury and damage to property.
AAA Battery Installation
1. Unfasten tail cap and remove battery holder.
2. Insert 3 AAA batteries following the correct
polarity (+,-) marked on the battery holder.
3. Insert the battery holder back into the
flashlight with the positive (+) end first.
On/Off
Zoom
1. Hold both ends of the flashlight; gently twist and pull each end away from the
other.
2. Pull the two ends away from each other to zoom in and push the two ends
together to zoom out.
To turn the flashlight on, press down firmly on the red power button located
on the tail of the flashlight until you hear a click.
To turn the flashlight off, press down firmly again until you hear a click.
There is a single lighting mode. (High)
18650 Lithium-ion Rechargeable Battery Installation (See Warning)
1. Insert one 18650 battery inside the 18650 clear battery tube.
2. Insert the combined 18650 battery and clear tube into the flashlight with the
positive (+) end first.
GETTING STARTED
OPERATION
ZOOMABLE
RUBBER
O-RING
AAA
BATTERY
HOLDER
TAIL CAP
WARNING:
Remove the batteries if the flashlight is not working properly.
Failure to do so may result in personal injury and damage to property.
POSITIVE
NEGATIVE
BELT CLIP
ANTI-ROLL
DESIGN
HIGH
MODE
