GEAppliances AEW06, Owner'S Manual And Installation Instructions

Page: 5 / 15

5
GEAppliances.com
Cool Mode
Use the Cool mode at Low, Med, High or Auto Fan Speed
for cooling. Use the Temperature Increase
Ÿ
/ Decrease
ź
pads to set the desired temperature between 64°F and 86°F
in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off to keep
the room at the set level of comfort. Set the thermostat at a
lower number and the indoor air will become cooler. Set the
thermostat at a higher number and the indoor air will become
warmer.
NOTE: If the air conditioner is off and is then turned on
while set to a Cool setting or if turned from a fan setting to
a Cool setting, it may take approximately 3 minutes for the
compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling
³6HOHFWWKH
Cool mode and High or Med
fan with a middle set temperature.
For Maximum Cooling
³6HOHFWWKH
Cool mode and High fan
with a lower set temperature.
For Quieter and Nighttime Cooling
³6HOHFWWKH
Cool mode
and Low fan with a middle set temperature.
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan speed to
provide air circulation and filtering without cooling. Since
fan-only settings do not provide cooling, a Set temperature
cannot be entered. The room temperature will appear in the
display.
NOTE: Auto Fan Speed cannot be used when in the
Fan Only Mode.
Energy Saver Mode
In the case of a power outage or interruption, the unit will
automatically restart in the settings last used after the power
is restored. If the
Delay 1–24hr feature was set, it will resume
countdown. You may need to set a new time if desired.
Power Outage Recovery Feature
Set to Auto fan speed for the fan speed to automatically set
to the speed needed to provide optimum comfort settings
with the set temperature.
If the room needs more cooling, the fan speed will
automatically increase. If the room needs less cooling, the fan
speed will automatically decrease.
NOTE: Auto Fan Speed cannot be used when in the Fan Only
Mode.
Auto Fan Speed
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for freezing
outdoor conditions. It must not be used in freezing outdoor
conditions.
„
To ensure proper operation, aim the remote control at the
signal receiver on the air conditioner.
„
Make sure nothing is between the air conditioner and the
remote control that could block the signal.
„
The remote control signal has a range of up to 20 feet.
„
Make sure batteries are fresh and installed correctly as
indicated on the remote control.
„
Remote contains a magnet allowing it to attach to metal
surfaces.
Remote Control
This mode optimizes the cooling power of your air
conditioner, thereby saving you energy. Once the set
point temperature has been reached, the fan will cycle
off to save energy. The fan will cycle back on periodically
to insure all cooling capacity in the system is used. This
mode is the default mode for the unit. Each time the unit is
powered off, it will restart in Energy Saver mode ON . This
includes Delay timer mode. The first time the unit is turned on,
the settings will be 70° and Low fan. You can adjust the fan
speed and temperature to your personal comfort.
Energy Saver ON
³
Helps minimize electricity use. It is
normal for the fan to cycle off and then back on in this
mode. This on/off cycle can repeat multiple times. Because
the fan will cycle off, you may notice a variation in room
temperature and humidity.
Energy Saver OFF
³
When this mode is not engaged, the fan
will run continuously, and in Cool mode the compressor
will cycle on and off to maintain room temperature.