Handling and Assembly
Anchor bolt installation procedure
2008-9015-001
01-2017
5.5
Anchor bolt installation procedure
Attention!
Wait at least 7 days before drilling into concrete so that the slab has harden
sufficiently.
Bolt diameter
3/8” [10mm]
1/2” [13mm]
3/4” [19mm]
Bolt length
(A)
3” [76mm]
2 3/4” [70mm]
3 3/4” [95mm]
3 3/4” [95mm]
5 1/2”
[140mm]
Material
Steel
Steel
Steel
SS 304
Steel
Minimum hole depth
(Ho)
2 5/8” [67mm]
2” [51mm]
2 5/8” [67mm]
2 1/2”
[63.5mm]
4 1/2”
[114mm]
Hnom
2 3/8” [60mm]
1 3/4” [45mm]
2 1/4” [57mm]
2 1/4” [57mm]
4 1/4”
[108mm]
Hmin
4” [101mm]
4” [101mm]
4” [101mm]
4” [101mm]
6” [152mm]
Concrete drill bit
diameter
(Dia.)
3/8”
[10mm]
1/2”
[13mm]
1/2”
[13mm]
1/2”
[13mm]
3/4”
[19mm]
Torque
20ft-lb (25Nm)
40ft-lb (54Nm)
40ft-lb (54Nm)
40ft-lb (54Nm)
110ft-lb
(150Nm)
● Position the component on the concrete surface.
● Drill through the holes of the component to 3 ¾” depth (1).
● Remove the particles inside the holes (2).
● Insert the anchor bolts. Keep 1 ½” of length exceeding from the concrete
surface.
● Tap the anchor bolt using a hammer until it firmly secures the component.
● Tighten the assembly to appropriate torque. Refer to the following table.
● Cut the exceeding threads of the bolts when indicated.