09
430
-08
.2
01
6-
Gb
13
Assembly instructions for HGX46 CO
2
T up to design key A053
¾
Insert the feather key.
¾
Align the stator so that the cable harness is positioned upwards and the feather key is aligned with the groove of the
stator.
X
Do not damage any cables and components
. Push the stator with the cables leading, into the motor housing until
the stop. At the same time, carefully pull the cables upwards through the terminal board opening.
¾
For the threaded pin (2) (M8x16), a countersink has to be provided.
X
For this purpose use a drill with Ø 6.8 mm and a drill tip of 90°
.
¾
Bore a hole into the stator by observing the dimension
Y = 62,4
-0,5
mm
, but only use a drill with cone tip.
X
Carefully remove the chips
(e.g. with a vacuum cleaner)
.
WARNING
The heavy weight of the stator can potentially be dangerous; risk of falling, danger of crushing.
X
Use a suitable hoist for the removal.
X
Note the direction of the feather key — stator.
You must align the parts in order to install them.
Y
¾
For clamping the feather key to the stator, a threaded pin (1) (M8x20) without tip is used (see figure).
¾
Screw in the new threaded pins, see page 15.
Threaded pin (2) for stator protection
Threaded pin (1) for clamping the feather key
max.
75kg
Assembly
Summary of Contents for Bock HGX2 CO2 T Series
Page 23: ...09430 08 2016 Gb 23 ...
