3
A
Step
13
3/4" Custom Panels
Models ZBD4800X Dishwashers
Locate the access panel template provided.
• Place the template on the back side of custom
access panel with top edges and sides aligned.
• Use an awl or punch to mark 4 screw hole
locations.
• Remove the template and drill four 3/32"
pilot holes 3/8" deep in the marked locations.
• Place the mounting brackets on the access
panel, aligning screw holes.
• Secure the brackets to the panel with four
screws (A) provided.
• Drop the access panel with mounting
brackets into the slots on the assembly and
push down.
• Set the access panel assembly and custom
panel aside. Do not reinstall until final
installation is completed.
(continued)
Install
Custom
Access Panel
to Assembly
Screw A
Remove
Plastic
Chassis
Cover
Remove 2 Screws
Remove the two screws with spacers on each
side of the plastic chassis cover.
• Lift and rotate upwards until the chassis
cover snaps out of position. Remove and set
aside. Do not re-install until final installation
is completed.
Access Panel T
emplate
Custom
Panel
